UNO Drum
5 – Presets
33
5 – Programming a Sequence
The sequencer can manually program one element at the time, after the selection of the element.
Note: An element pattern can be randomized using the RANDOM button.
5.1 – Insert a trig
To insert a trig in an element pattern, select the element and press the steps where you want to insert a trig. The
inserted trig will have the HIGH velocity value of the Pad which is 127.
Holding the element while inserting a trig will have the LOW velocity value of the pad which is 100.
To remove a trig, press the step again. To change the velocity value from HIGH to LOW, hold the element pad
and press the step. To change Velocity value from LOW to HIGH press the step once to delete it and again to
insert the trig.
When a trig is deleted the automated parameters on the step are also deleted.
5.2 – Automate a trig
A step where a trig is inserted can store up to 8 parameters depending on the element. Automation on a trig can
be inserted only when REC is active. The PLAYback can be ON or OFF independently. Hold the step you want
to automate and move the desired parameter (which can be on the DRUM row or the VELOCITY located in the
SEQ row).
To remove an automated trig, it is necessary to press CLEAR + the desired step. Remove and reinsert the trig
while the sequencer REC is OFF.
5.3 – Automate a pattern
An element pattern can be automated when the REC is active and the PLAYback is ON.
Select an element to tweak the desired parameter in the DRUM row or the VELOCITY in the SEQ row during the
playback.
The recording is stopped when REC is pressed again.
A ROLL effects can be recorded in the pattern.
