Getting to know your MYLO lights
PRECAUTIONS:
• Keep the fixture away from water and all flammable gases or liquids.
• Use only the recommended batteries.
• Handle the unit with care.
• DO NOT attempt to disassemble or repair the unit without first contacting service department at
ikancorp.com.
• Keep the unit clean and free of dust. The unit can be cleaned with a soft dry cloth.
• Use only parts provided by the manufacture.
• Always use caution when plugging in the fixture.
Mounting the Mylo to a Stand:
The Mylo LED Light comes with a pre-installed yoke and combo mount. This allows the fixture to easily
sit and adjust on any stand. The yoke allows the light to move freely, without obstruction. The Baby
5
/
8
"
and Junior 1-
1
/
8
" Combo Pin allows the user a wide range of stands. The light can be mounted either
horizontally or vertically on a
5
/
8
" baby pin.
Power the LEDs:
The Mylo light comes with an included AC power supply and 6 foot cable. This allows the user to plug into
any standard 120-240v electrical outlet. The Mylo LED Light can be powered from one of two Sony “L”
Style batteries that are supplied with the unit.
Adjusting the Color & Brightness of the Light:
The Mylo LED Light is controlled by the large yellow knob on the rear of the fixture. The knob was designed
with the idea that it could be reached and adjusted when the light is up on a stand. The knob has three
push settings.
1. The default setting is the brightness from 10%-100% brightness.
2. By pressing in on the knob the color temperature can be adjusted. (Bi-Color Lights)
Mylo Battery Operation
You can charge your Sony style “L” Series DV batteries at the same time.
Connect the power cable to the AC charger and plug it into the wall.
1. Place one or both battery packs onto the charger and slide it towards the indicator lights.
2. The indicator lights will illuminate with how much charge is left on the battery.
3. The charger will begin charging when the battery is fully inserted into the charger.
(Note: The battery is fully charged when all lights are a solid red.)
Attaching the battery pack to the back of the Mylo light fixture can be done by placing the battery against
the back of the Mylo battery port and sliding it forward.
Properly store the “L” Series batteries when not in use. If the “L” Series batteries will not be used for awhile,
run down the battery and store it with the Mylo fixture.
