IKEA 10394266, Manual

ENGLISH 19

•  Before touching the light bulbs, 

ensure that they are cold.

•  Do not use or leave the hood 

without the light bulb correctly 

fitted, as this may cause electric 

shock.

•  The hood is not a work surface, 

therefore do not place any 

objects on top of it or overload 

it.

•  During all installation and 

maintenance operations wear 

appropriate working gloves.

•  This appliance is not suitable 

for outdoor use.

WARNING:

 when the hob is in 

use, accessible parts of the 

hood may become hot.

Installation and connection

In the event of problems, contact 

the Authorized Service Centre. To 

prevent any damage, only remove 

the appliance from its packaging 

at the time of installation.

Preparing for installation

WARNING:

 this is a heavy 

product; the hood should only 

be lifted and installed by two or 

more people.

The minimum distance between 

the hob and the bottom part of 

the hood must not be less than 65 

cm for burning gas or other fuels 

and 50cm for electric cookers.

Before installation also check the 

minimum distances stated in the 

manual of the cooker.

If the installation instructions 

for the cooker specify a greater 

distance between cooker and 

hood, this distance must be 

observed.

Electrical connection

Make sure the power voltage 

specified on the appliance rating 

plate is the same as the mains 

voltage.

This information can be found 

on the inside of the hood, under 

the grease filter. Power cable 

replacement (type H05 VV-F) 

must be carried out by a qualified 

electrician. Contact an authorized 

service centre.

If the hood is fitted with an electric 

plug, connect the plug to a socket 

complying with current regulations, 

located in an accessible place. 

WARNING:

 if no plug is fitted 

(direct wiring to the mains), or 

if the socket is not located in an 

accessible place, a qualified 

electrician should install a 

standardised double pole power 

switch that will enable complete 

isolation from the mains in case of 

category III overvoltage 

conditions, in accordance with 

wiring rules.