19
Gas pressure regulator
4.
Remove the access cap by using a wrench, turning the
access cap counterclockwise.
5.
Remove spring retainer from the cap by pushing against the
flat side of the spring retainer. Look at the spring retainer to
locate the “LP” or “NAT” position.
6.
Turn over the spring retainer so the “NAT” is showing on the
bottom.
7.
Snap the spring retainer back into the cap.
8.
Reinstall the cap onto the regulator.
To Convert Standard Surface Burners
1.
Remove burner cap.
2.
Remove burner base.
3.
Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
4.
Gas orifice spuds are stamped with a number on the side.
Replace the LP gas orifice spud with the correct Natural gas
orifice spud.
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart for Standard Surface Burners
5.
Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
6.
Repeat steps 1-6 for the remaining burners.
7.
Replace burner base, burner head and burner cap.
8.
Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
9.
Complete installation. See “Make Gas Connection” and
“Electronic Ignition System” sections.
Checking for proper cooktop burner flames is very important.
Natural gas flames do not have yellow tips.
IMPORTANT:
You may have to adjust the “LO” setting for
each cooktop burner. See “Make Gas Connection” and
“Electronic Ignition System” section.
A. Access cap
B. Gasket
C. Gas pressure regulator
D. Spring retainer NAT position
E. Spring retainer LP position
A. Orifice spud
A
B
C
D
E
LP
LP
A
A. Stamped number
Burner Location
Burner Rating
Size
Right front
Left front
Center
Right rear
Left rear
3,5000 Btu/h
6,000 Btu/h
11,000 Btu/h
6,000 Btu/h
10,000 Btu/h
0.90 mm
1.20 mm
1.55 mm
1.20 mm
1.50 mm
A
XXX
