IKEA 90444984, Manual

ENGLISH 8

and in a place suitable for its size 

and use. Make sure the appliance 

is not near a heat source and 

that the four feet are stable and 

resting on the floor, adjusting them 

as required, and check that the 

appliance is perfectly level using a 

spirit level. Wait at least two hours 

before switching the appliance on, 

to ensure that the refrigerant circuit 

is fully efficient.

WARNING:

 When positioning 

the appliance, ensure the supply 

cord is not trapped or damaged.

WARNING:

 To avoid a hazard 

due to instability, positioning 

or fixing of the appliance must 

be done in accordance with the 

manufacturer instructions. It’s 

forbidden to place the refrigerator 

in such way that the metal hose 

of gas stove, metal gas or water 

pipes, or electrical wires are in 

contact with the refrigerator back 

wall (condenser coil).

 To guarantee adequate 

ventilation, leave a space on both 

sides and above the appliance. 

The distance between the rear of 

the appliance and the wall behind 

the appliance should be 50 mm, 

to avoid access to hot surfaces. A 

reduction of this space will increase 

the Energy consumption of product. 

Please remove the power cord from 

condenser hook during installation 

before connecting product to 

power supply.

ELECTRICAL WARNINGS

 It must be possible to 

disconnect the appliance from the 

power supply by unplugging it if 

plug is accessible, or by a multi-

pole switch installed upstream of 

the socket in accordance with the 

wiring rules and the appliance 

must be earthed in conformity with 

national electrical safety standards.

 Do not use extension leads, 

multiple sockets or adapters. 

The electrical components must 

not be accessible to the user 

after installation. Do not use the 

appliance when you are wet or 

barefoot. Do not operate this 

appliance if it has a damaged 

power cable or plug, if it is not 

working properly, or if it has been 

damaged or dropped.

 If the supply cord is damaged, 

it must be replaced with an 

identical one by the manufacturer, 

its service agent or similarly 

qualified persons in order to avoid 

a hazard - risk of electric shock.

WARNING:

 Do not locate 

multiple portable socket-outlets 

or portable power supplies at the 

rear of the appliance.

 Feets of the product: in Fs not 

available;in built in - the “feet are 

not adjustable - and the METOD 

cabinet should be levelled with 

spririt level.