IKEA IKEA 702.329.02, Original Instructions Manual

10

lights up while the battery is being 

charged (7). 

Under normal conditions of use the 

screwdriver/drill can be recharged 

several hundred times. 

ATTENTION!  

The recharging process generates 

heat in the battery.

Note:

 The battery that is supplied with 

the screwdriver/drill has been charged 

for test purposes only and must be 

fully recharged before first time use.

First read the safety instructions and 

then follow the loading instructions. 

Insert the transformer plug into the 

socket in the screwdriver/drill. Then 

connect the charger's transformer to 

the electricity supply.

Make sure that there are no knots or 

sharp bends in the cable. 

The charger's transformer and the 

battery have been designed to be 

used together.

NEVER

 use this charger to recharge 

cordless tools or batteries from 

other manufacturers. The battery will 

gradually lose its charge over a period 

of time, even if the tool is not used. 

The lithium-ion battery is protected 

against deep discharging by the 

"Electronic Cell Protection (ECP)". 

When the battery is empty, the 

machine is switched off by means of a 

protective circuit: The inserted tool no 

longer rotates.

 WARNING  

Do not continue to press the On/Off 

switch after the machine has been 

automatically switched off. The battery 

can be damaged.

 WARNING!  

Recharge the battery on a non-

flammable surface.  Do not recharge 

the battery for more than eight hours. 

The red diode will turn green when the 

battery has been fully loaded.

Disconnect the cable and store the 

transformer in a suitable place when it 

is not in use.

It is not advisable to recharge the 

battery in temperatures below 

freezing.

INSTRUCTIONS FOR USE

Using the tool

Note:

 Sparks may be visible through 

the slots in the motor housing during 

operation. The sparks are a normal 

reaction of the motor when in use 

and are created by the components