ENGLISH
5
The manufacturer re ects all
responsibilities for an damage caused
b improper use or rong settings.
Appropriate maintenance and cleaning
ensure the good orking order and
the best performance of the appliance.
egularl clean all stubborn surface dirt
to avoid grease build up. emove and
clean or change the filter regularl .
ever ame cook food ambé under
the appliance. sing free ames might
cause fire.
ailure to observe the instructions for
cleaning the hood and replacing the
filters ma result in a fire.
E haust air must not be vented through
a ue used for removal of fumes
produced b gas combustion appliances
or other combustible materials but must
have a separate outlet. All national
regulations governing e traction of
fumes must be observed.
There shall be adequate ventilation if
the hood is being used at the same time
as other appliances using gas or other
combustible materials. The negative
pressure of the room must not e ceed
Pa
bars . or this reason ensure
that the room is ell ventilated.
Do not leave fr ing pans unattended
hen fr ing as the fr ing oil ma catch
fire.
Before touching the light bulbs ensure
that the are cold.
Do not use or leave the hood ithout
the light bulb correctl fitted as this ma
cause electric shock.
The hood is not a ork surface therefore
do not place an ob ects on top of it or
overload it.
During all installation and maintenance
operations ear appropriate orking
gloves.
This appliance is not suitable for outdoor
use.
ARNING
hen the hob is in use
accessible parts of the hood ma
become hot.
I
After unpacking the appliance check for
an transport damage. In the event of
problems contact the Authorized Service
Centre. To prevent an damage onl
remove the appliance from its pol st rene
foam packaging at the time of installation.
ARNING
this is a heav product the
hood should onl be lifted and
installed b t o or more people.
The minimum distance bet een the hob and
the bottom part of the hood must not be less
than cm for burning gas or other fuels
and cm for electric cookers.
Before installation also check the minimum
distances stated in the manual of the cooker.
If the installation instructions for the cooker
specif a greater distance bet een cooker
and hood this distance must be observed.
E
ake sure the po er voltage specified on
the appliance rating plate is the same as
the mains voltage.
This information can be found on the inside
of the hood under the grease filter. Po er
cable replacement t pe
must
be carried out b a qualified electrician.
Contact an authorized service centre.
If the hood is fitted ith an electric plug
connect the plug to a socket compl ing ith
current regulations located in an accessible
place.
If no plug is fitted direct iring to the
mains or if the socket is not located in an
accessible place a qualified electrician
should install a standardised double pole
po er s itch that ill enable complete
isolation from the mains in case of categor
III overvoltage conditions in accordance
ith iring rules.
Summary of Contents for MOLNIGT
