3
①
Lens mount (CS mount)
Accepts many types of CS mount lenses.
②
C mount adaptor (Accessory)
Attached to the lens mount to accept many types of C mount lenses.
③
Flange focal distance adjuster
Used to adjust the flange focal distance depending on the type of lens used. Helpful when the lens’ focus
ring fails to put into focus.
④
Flange focal distance lock screw
Used to mechanically lock the flange focal distance after fine adjustment of it.
⑤
Holder screw hole
Used to mount the camera onto the camera holder. Effective for general camera tripods.
Note:
Be sure to use less than 5.5mm- long setscrew (1/4” – 20 UNC) for mounting the camera to tripods or
holder.
⑥
Lens selector switch
Used to choose between the video iris and the DC iris depending on the type of auto iris lens used.
⑦
Auto iris lens connector
Specifically used to connect the auto iris lens. Use the connector plug that is attached to the camera.
• For video type auto iris lens
Set the lens selector switch to VIDEO position.
— Connector cable leads —
1. Red (power)
2. Not used
3. White (video)
4. Black (shielded)
* Dress the tip of the green lead to prevent a short-circuit.
• For the DC type auto iris lens
Set the lens selector switch to the DC position.
— Connector cable leads —
1. Damping coil (–)
2. Damping coil (+)
3. Driving coil (+)
4. Driving coil (–)
* Connect the leads as shown above. Refer also to the instructions of the lens.
Auto iris lens
2
4
1
3
Auto iris lens
2
4
1
3
Number of connector pins
2
4
1
3
