www.ikegps.com/quickstart
Page 99
www.ikegps.com/support
Resetting the device:
Some programs require you to reset your device during the
installation process. Follow the steps below to reset ike:
1. Save your open files and close any running programs. (For instructions on backing
up files, see the
Backing up data
section)
2. Press and hold the Power button until the Power Button menu appears, then
release the Power button.
3. Tap the on-screen [Reset] button to perform a soft reset.
If your device locks up, you can reset the device by pressing and holding the Power button
for 10 seconds or until the screen goes dark. After a few seconds, if there is sufficient
charge in the battery, the device will reset and turn on again.
Restoring the device to its factory state:
Follow the steps below to restore the user
storage, settings, and icons on your ike to their original factory defaults.
WARNING!
Restoring ike to its original factory state will permanently erase data saved
on, any software you installed, and any changes you made to ike, including settings
changes. Following this operation, you will need to reinstall ikeOS from the ike
Software and any other CDs provided.
Option A: ikeOS Zeroize Utility
Select Start > ikeUtilities > Zeroize.
Check the
Zero Storage Card
option if desired, then Confirm or Cancel the operation.
WARNING!
Selecting the
Zero Storage Card
option will cause all data in the
\Storage folder and on any fitted SD Card to be permanently deleted. Only select this
option if you intentionally wish to destroy all data in the \Storage folder and on the SD
Card.
CAUTION:
Using the
Zero Storage Card
on larger capacity SD/SDHC cards may take
some time to process and can potentially corrupt the card if interrupted. If you need to
clear content of larger capacity SD Cards, we recommend removing the card and
deleting/reformatting via a SD Card reader attached to you desktop PC
.
Note: more information is given on the Zeroize Utility in
the ‘ikeUtilities’ section of the
ikeBasic chapter.
Option B: Hardware Restore
Reset the device from the power button menu or by holding down the power button
until the display goes dark.
When the green notification LED light appears on the front of your ike, simultaneously
press and hold the following buttons for several seconds:
o
Clean Boot: Home, up arrow, Context
o
Clean Storage: Task, up arrow, Return
o
Clean Registry: Start, Context
o
Clean All: Return, left arrow, Context
Hold the buttons until the progress bar reaches the second tick mark and then
disappears. Factory settings are restored automatically.
