www.ikegps.com/quickstart
Page 102
www.ikegps.com/support
CAUTION:
Releasing the hand strap hook too quickly may result in injury or damage to the
display. Use caution when undoing the hook or when holding your ike by its hand strap.
1. Press on the battery door about 1/4
”
beneath the door latch and slide the door latch to
the right.
2. Remove the battery door.
Note: The door may make a noise while it is being removed,
caused by the door scraping against the battery.
The sound is normal; no damage is
done when you hear this sound.
3. Remove the old battery pack.
4. Make sure the battery contacts of the charged battery pack are clean and dry.
5. Insert the charged battery pack, lining up the battery contacts with your ike contacts.
6. Insert the tabs on the bottom of the battery door into the case slots.
7. Close the battery door, making sure the door latch is in the unlock position as the door
meets the case.
8. With the door latch in the unlock position, press on the battery door just below the door
latch and slide the latch to the left to lock it.
9. Reattach the hand strap.
Note: If you remove the battery pack from your device and the device is still attached to
the wall charger, the battery icon still appears on the display. When the battery is
replaced, charging resumes.
For instructions on installing or charging a battery pack, see
Getting Started.
For
instructions on maintaining and caring for your battery pack, see
Caring for your ike
.
Using peripheral devices such as SD cards and USB flash drives
ike accepts several peripheral devices. The USB Host (mini A) accepts devices like USB
flash drives and keyboards; the Secure Digital (SD) card slot accepts SD/SDHC memory
cards.
Note: Your ike has integrated Bluetooth
®
technology; see later sections of this manual for
more details about using Bluetooth
®
peripheral devices with ike.
This section explains how to:
Install and operate USB accessories on your ike
Install its SD card
Replace its SD card
Copy files from a SD memory card or USB drive
Installing and operating USB devices on ike.
The USB Host accepts several USB
devices, including keyboards and USB flash drives.
Note: To be compatible with Windows Mobile
®
6, some USB serial devices require drivers.
Refer to your USB device
’
s manual or contact the manufacturer to determine compatibility.
To install a USB device, plug the mini end of a USB communications cable into the USB
Host (labeled A on your device). You may need to use a USB mini-to-full size adapter.
Installing an SD card:
To operate a SD card, insert the card into the SD card slot
(located above the screen under the SD card cover) on your ike. If the card has been
correctly formatted, the system will automatically detect and add the card to the list of
