16
•
Check the camera settings.
•
Check cable connections.
•
Refer to troubleshooting at www.ikelite.com/blogs/faq
Strobe will not fire when using sync cord
•
Make sure the strobe is turned on.
•
Try a different sync cord.
•
Restore camera to factory default settings and then re-configure
according to the housing instructions.
Strobe will not fire when using an optical sensor
•
Make sure the strobe is turned on.
•
Make sure the signal flash is firing.
•
Make sure the strobe sensor is pointed directly towards the signal
flash.
•
Move the strobe sensor closer to the signal flash.
Ready light does not come on
•
Charge or replace batteries.
•
Make sure batteries are facing the correct direction when installed
•
Make sure the strobe is turned on.
Backscatter or “snow” in images
•
Position strobes or lights farther away from your lens and at a slight
angle.
•
Avoid using strobes in extremely turbid conditions.
