15
•
The Ready Light LED doubles as a confidence signal. The LED
will momentarily glow green after the strobe fires if the strobe has
received a TTL quench signal.
•
If the Ready Light does not glow red, check that the battery pack
is fully charged and the strobe power switch is set to the ON or ON
W/LITE position.
Maintenance
Post-Dive
1.
Rinse your strobe and camera system in fresh water. Do not
remove the battery pack or sync cord prior to rinsing.
2.
NEVER leave your system in a fresh water rinse tank. Collisions
with other peoples’ gear can cause scratches or damage to your
equipment.
3.
Stow your system in a shaded place where it is protected from
impact or overheating. If no shade is available, we recommend
covering the system with a towel or cloth.
4.
Check the memory card capacity and battery life of your camera
and strobe(s). Recharge as necessary.
5.
Always re-check o-ring seal after removing the battery pack from
the strobe. Most importantly, make sure the o-ring is in place prior
to re-attaching the battery pack.
Travel and Storage
1.
Remove the sync cord or triggering device from the strobe’s
bulkhead.
2.
Lightly lubricate the threads of the bulkhead. Be careful not to get
lubricant inside the gold connectors or rubber grommet inside of the
bulkhead.
3.
Attach the waterproof bulkhead cap to the bulkhead.