18
Strobe will not fire when using sync cord.
•
Make sure the strobe is turned on.
•
Try a different sync cord.
•
Restore camera to factory default settings and then re-configure
according to the housing instructions.
Strobe will not fire when using an optical sensor.
•
Make sure the strobe is turned on.
•
Test fire the strobe through the bulkhead. If it does not fire through
the bulkhead, then the strobe must be returned for repair.
•
Make sure the signal flash is firing.
•
Make sure the strobe sensor is pointed directly towards the signal
flash.
•
Move the strobe sensor closer to the signal flash.
Ready light does not come on.
•
Charge or replace battery pack.
•
Make sure the strobe is turned on.
Backscatter or “snow” in images.
•
Position your strobe(s) farther away from your lens and at a slight
angle.
•
Avoid using strobes in extremely low-visibility conditions.
