10
10
Diffuser
Cut-out
Section
The factory installed flash Deflector should be removed when using
ONLY the built-in camera flash and no external strobes. Lift the bottom
of the Deflector with a Pen or Pencil to loosen and pull the Deflector
away from the inside front of the housing to remove. To install, line up
the corresponding Velcro dots on the housing front and press the
Deflector back into its factory installed position next to the lens port.
Deflector Removal/Installation
Deflector Front
Diffuser Purpose
When shooting close-up photographs, the lens port on the housing can
block a portion of the light from the built-in camera flash. This can result
in a shadow in a lower corner of the picture frame. The Diffuser will help
eliminate the shadow. In addition, you can zoom in if necessary.
Small hole
The included Diffuser should only be used when
shooting with the built-in camera flash. Always
remove the Deflector
before
using ONLY the
built-in camera flash with a Diffuser.
To install the diffuser, push the “Cut-out” Section
into the port groove until it stops as shown. To
remove, grab the top of the Diffuser and pull
away from the port.
Note the Small Hole. To avoid losing the diffuser,
you can attach a fishing line or string to this hole.
Diffuser Installation/Removal
Diffuser properly
installed in port groove
Velcro
Bottom of Deflector
(view from inside housing)
