Control Maintenance -
continued
- Some of the controls have long shafts and feature a
hex
style control
gland. These controls can be pulled out, exposing the shaft, Diagram C,
page 15.
To lubricate the control, gently pull on the knob until the stainless steel
shaft is exposed. Lightly lubricate the shaft, then move the shaft in and
out several times. This will lubricate the x-ring in the Ikelite control gland.
This should be done before using the housing after a prolonged storage
period, or once a week when the housing is in constant use.
- Some of the controls have a short shaft and cannot be pulled out
exposing the shaft for lubrication. In the unlikely event one of these
controls sticks or becomes difficult to operate you can remove the
control from the housing and lubricate it, or return the housing to Ikelite
for maintenance. To remove the control, Diagram D, page 15, loosen the
set screw in the knob (allen wrench required); remove the knob. If there
is salt or dirt build-up on the exposed control shaft, clean the shaft.
Open the housing and gently slide the control shaft out of the control
gland. Clean and lightly lubricate the shaft, including the end of the
shaft. Slide the shaft back into the control gland and gently slide the
shaft back and forth a few times without fully removing the shaft from the
gland. Replace the knob noting the flat area on the shaft. The set screw
in the knob should tighten down against the flat area on the control, so
the knob does not turn on the shaft.
Close housing
without
a camera inside and water pressure test in a
bathtub or swimming pool. Rotate
*
the knobs to make sure the housing
is watertight and the gland was installed properly. Check all controls
while the housing is submerged.
*
Caution:
If your housing has a shutter spring,
DO NOT
rotate the
shutter control more than 1/16th of a rotation, otherwise, you may
accidentally bend the shutter spring or cause the spring to “pop off” the
control shaft.
14
