12
Closing the Housing
1.
Make sure the o-ring is clean and in its proper location on the back
of the housing. The main housing o-ring does not require lubricant
to make a seal.
2.
Place the back onto the housing front.
3.
Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4.
Place each lid snap into the corresponding hook on the housing
back.
5.
Push the lid snaps towards the housing until they are flat against
the housing and the lock has engaged. Close opposing lid snaps at
the same time.
6.
Check the o-ring seal and control functions. The o-ring should form
a uniform, solid line around the back of the housing. There will be a
small, even gap around the housing between the housing back and
the housing front.
Installing Zoom Clamp and Gear Sleeve
Determine if you have a Type 1 or Type 2 lens and attach zoom clamp
and sleeve as shown, if you are using zoom. Type 2 lenses must be
attached to the camera as shown, after the camera has been installed
in the housing. DO NOT rotate housing zoom control until AFTER the
port is installed.
