19
Travel and Storage
1.
Remove the camera from the housing for travel or storage.
2.
Check the main housing o-ring.
3.
Close the empty housing and submerge in lukewarm fresh water.
While submerged, rotate each control and depress each button to
flush out any salt or debris.
4.
Remove the housing from water and rinse with running water.
5.
Do not rinse the inside of the housing or submerge the open
housing in water. If the inside of the housing needs to be cleaned,
wipe with a clean, slightly damp cloth.
6.
Dry the housing with a clean, lint-free cloth.
7.
Store in a cool, dry place.
8.
Like regulators and other pressure-sensitive equipment, we
recommend careful care and cleaning along with annual
replacement of the factory seals.
Troubleshooting
Water enters the housing
•
Re-clean and re-install the main o-ring.
•
Take the housing underwater without a camera installed to ensure
that the leaking has been corrected.
Photos are over-exposed (too light)
•
Adjust aperture (smaller), shutter speed (faster), or ISO (lower)
setting.
•
Move light(s) farther away from your subject.
•
Adjust exposure compensation in the camera.
