23
Before using the housing, always check the tightness of the set
screw in each control knob. Check each control gland penetrating
the housing to make sure they are tight. There is a slight chance that
either could vibrate loose during travel.
Keep area where the o-ring fits and sealing surface of the housing
clean.
Rinse the housing exterior thoroughly in freshwater after each
saltwater use. Depress push buttons repeatedly in freshwater to
eliminate trapped saltwater. Dry with a soft cloth. Dry lens port to
eliminate water spotting. After several uses in saltwater, soak the
housing exterior in a mild soap solution; rinse and dry before storing.
When storing the housing, remove the main housing o-ring, lightly
lubricate, and place in a plastic bag. Do not stretch the o-ring. Place
the plastic bag with o-ring inside the housing for safe keeping.
Leave lid snaps in the open position when not using the housing for
extended periods.
Always disassemble and clean the housing Tray/Handle(s) before
storage. Over time, corrosion can make components difficult to
disassemble.
Control Maintenance
Ikelite controls are designed to provide years of reliable service with
minimal maintenance.
Push button controls normally require no maintenance other than
rinsing in fresh water after saltwater use. Depress each push button
in fresh water several times to eliminate trapped saltwater. If a push
button control becomes difficult to push or if it sticks when depressed,
soak the housing in lukewarm fresh water. After a few minutes,
operate the push button. If this does not correct the problem, return
the housing to Ikelite for maintenance. If you are on a trip and unable
to return the housing immediately, a push button may be lubricated by
pressing and holding the push button all the way in. Then, use your
finger or other small non-metal object to place a small amount of lube
at the base of the shaft inside the housing.