11
3.
Continuously repeating above operation steps for oil ejection before oil contained
in the cylinder reaching “STOP” level on the sticker of cylinder
TIPS
It will be faster for transferring of waste oil from transparent measuring glass into oil
tank, if vacuum generated in both transparent measuring glass and oil tank.
Oil ejection from oil tank to external waste oil tank
When the oil retained in tank near full(see oil window), You need to eject oil out into a
disposal tank and resolve the waste oil according to the instruction of local
government.
1.
Make sure the ball valve(fig 1) and wing valve(fig 1) are closed
2.
open the left ejection valve(see fig 1)
3.
hook the ejection hook on the external disposal tank.
4.
connect the compressed air with the air inlet fixed on the top of the tank then turn
on the air inlet valve
gradually and slowly
, the oil will be transferred to the
external disposal tank
5.
after ejection Turn off all the valves and remove all pipes, oil drum and machine to
the original places.
WARNING!!!
Please hold the end of Ejection Hook to avoid waste oil spattering
out, cause an injury of eye, dirty of clothes.
Safety Device
1. A safety valve will release pressure when pressure is
over 14PSI/1kgs
during
ejection.
2. A safety device was fixed on the top of the cylinder which could avoid the
cylinder exploding while the compressed air enter the cylinder
