• Before proceeding to adjust or repair the device,
make sure to stop the engine and detach the spark
plug cap from the spark plug.
• If the machine should be stored for a longer time,
drain fuel from the fuel tank and carburettor, clean
the parts, take the device to a safe place and make
sure that the engine has cooled down.
• Periodically perform inspections to ensure safe and
efficient operation of the device. Please contact
your dealer for a more comprehensive inspection of
your device.
• Keep the machine away from fire or sparks.
• It is assumed that a condition called Raynaud‘s
syndrome affecting the fingers of certain individu-
als may be brought about by exposure to vibration
and cold. Exposure to vibration and cold may cause
tingling and burning sensations followed by loss of
colour and numbness of the fingers. The following
precautions are strongly recommended as the mini-
mum exposure which might trigger the condition is
unknown.
• Keep your body warm, especially the head, neck,
feet, ankles, hands and wrists. Maintain good blood
circulation by performing vigorous arm exercises
during frequent work breaks and also by not smok-
ing.
• Limit the hours of operation. Try to fill each day with
jobs where operating the brush cutter or other hand-
held power equipment is not permanently required.
• If you experience discomfort, redness and swelling
of the fingers followed by whitening and loss of feel-
ing, consult your physician before further exposing
yourself to cold and vibration.
• Always wear ear protection, loud noise over a long-
er time may make cause hearing defects or even
deafness.
• Full face and head protection must be worn to pre-
vent injuries from falling objects or branches.
• Wear grip-safe heavy-duty work gloves to improve
your grip on the brush cutter handle. Gloves also re-
duce the transmission of vibrations to your hands.
• WARNING: The operating range of the cutter is still
dangerous while the device is coasting to a halt.
GB-4
ASSEMBLY
INSTALLING THE PROTECTION COVER
GEGEAR BOX
M5xl6
SCREWS
BRACKET
PROTECTION COVER
Install the protection cover on the unit’s main tube us-
ing the protection cover bracket and screws provided.
Put the protection cover in the correct position and
tighten the screws.
Attention :
For cutting with a metal blade, the black
extension piece of the protection cover must be re-
moved. For cutting with the nylon line cutter, the black
extension of the protection cutter must always be at-
tached.
INSTALLING THE HANDLE
LEFT HANDLE
RIGHT HANDLE
M5x25
SCREWS
BRACKET
CAP, UPPER
Install the handle on the bracket. Put the handle in a
comfortable operating position and tighten the four M5
X 25 screws.
