GB-4
to change the damaged tine; it is not necessary to
replace the complete tine set.
• Loosen the screws on one side while holding the lock
nuts from the other side.
• Take off the damaged tine and replace it by a new
one.
Maintenance of the transmission
(Fig. 11)
The transmission lubricant (grease) should be checked
and/or filled up about every 15 hours of operation or at
least once a year.
The inlet screw plug (1) for the transmission lubricant
is located on the right side of the transmission
housing.
Note: As the transmission heats up during operation,
the grease used to lubricate the transmission assembly
may liquefy to oil.
Put the tiller down on its left side and clean the
transmission housing before removing the drain
screw to prevent dirt and debris from getting into the
transmission.
Use an Allan key (hexagon socket screw key) to
loosen the screw.
Fill in as much grease (directly from the tube or using
a grease gun) until it comes out of the outlet bore.
Use commercially available transmission lubricant
(gear grease) of the type Mobil EPO or similar.
If necessary, disassemble tines.
Screw the inlet screw plug back in.
Storage
The tool should be stored in a dry and clean place and
out of the reach of children.
During extended periods of storage as, for example,
during the winter, ensure that the tool is protected against
corrosion and frost.
At the end of the season, or if the tool is not to be used
for longer than a month:
• Clean the tool.
• Wipe all metal surfaces with an oil-impregnated cloth
to protect them from corrosion (resin-free oil), or apply
a fine coat of spray oil.
• Fold the guide bar down, and store the tool in a suitable
place.
Repair Service
Repairs to electrical tools may only be carried out by
skilled electricians.
If you send the machine to us for repair, please describe
the fault.
Attention! Electrical repairs may only be carried
out by a skilled electrician or a customer service
workshop!
Waste disposal and environmental protection
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Please dispose of the device itself at an according
•
•
•
•
•
•
•
•
•
collecting/recycling point. By doing so, plastic and
metal parts can be separated and recycled. Information
concerning the disposal of materials and devices are
available from your local administration..
Summary of Contents for EM 700
