iks aquastar midi
33
When you have done this you can use the arrow keys to select
‘‘
Off
‘‘, ‘‘
On
‘‘ or ‘‘
Simulation
‘‘. If you want to cancel a process,
select ‘‘
Off
‘‘. You would normally select ‘‘
On
‘‘ here. Confirm
with
enter
(if you have chosen ‘‘
On
‘‘, you can skip the next
three steps).
If you have selected ‘‘
Simulation
‘‘, you can now enter the
latitude. Use the
F1 key
to change the
prefix. Confirm with
enter
.
Now enter the longitude. You can change the prefix with the
F1
key here too. Confirm with the
enter key
.
Now you can specify the time zones as well( e.g.. Be01
for Germany). You can change the prefix as required with the
+/-
key and then confirm with
enter
.
Now another socket is to be allocated to this function. This is
selected with the arrow keys. In the adjacent example it's the
socket 07. The display “(--)” shows that no further function has
been allocated to this socket. The socket can then be selected
by pressing
enter
. If a
non-variable-output socket
is
concerned, you can jump the following two paragraphs.
If you’re dealing with a
variable-output
socket you can first of
all enter the output of the socket for the period the interval
function is active. Please observe the restrictions regarding the
systems that can be connected (Section 4.3.2 e.g.
no HQI- or
HQL lighting
!) It’s best to connect the appliances now (e.g.
pump, lamp) to the appropriate socket. Enter, for example,
‘80%’ by entering
zero, eight, zero
(not
eight, zero
, as this
would mean 800%!). Now press the
del
key. The socket or the
appliance will now be supplied with the appropriate current. If
the results are not quite what you wanted then you can enter
another value and test it with
del
. Repeat this procedure as
often as you want until the setting suits you requirements.
Confirm your input with
enter
.
Now you can enter the socket output for “new moon” (the
lowest brightness of the moon). The procedure for this is the
same as before with ‘‘(On)‘‘. Make sure you use the
del
key’s
special function then confirm with
enter
.
Now use the arrow keys to select another time function or use
enter
to programme a further day/night simulation. Press the
Esc-key
to return to the main menu level.
Do not connect any HQI or HQL-lamps to a variable-output socket under any
circumstances whatsoever.
Lunar phase 3I
On
<>
Latitude? 3Y
+49,03
Longitude? 3Z
-8,24
Time Zone? 40
+01
Which socket? 29
No: 07 (--) <>
CntrlblSocket 2A
080% (On) del
CntrlblSocket 2A
020% (Off) del
Time functions 31
Lunar phase <>
Summary of Contents for aquastar midi
Page 25: ...iks aquastar midi 25 Notes ...
Page 54: ...iks aquastar midi 54 14 Notes ...
