0
1
Tx Cr 1
Cr 1
0
1
These instructi ons must be read carefully in order to install and use the set properly and to
keep it in perfect working conditi on and to reduce the risks of misuse.
Do not use this set on machines in potenti ally explosive atmospheres, except the models
certi fi ed ATEX/RATEX to work in that conditi ons.
a)
Strictly adhere to the instructi ons for installati on contained in this manual.
b)
Make sure that professional and competent personnel carry out the installati on.
c)
Ensure that all site and prevailing safety regulati ons are fully respected.
d)
Make sure that this manual is permanently available to the operator and maintenance personnel.
e)
Keep the transmitt er out of reach of unauthorised personnel.
f)
Remove the transmission key when the set is not in use.
g)
On starti ng each working day, check to make sure that the STOP butt on and other safety measures
are working.
h)
When in doubt, press the STOP butt on.
i)
Whenever several sets have been installed, make sure the transmitt er you are going to use is the
right one. Identi fy the machine controlled on the label for this purpose on the transmitt er or by
using the display (in case it has one).
j)
Service the equipment periodically.
k)
When carrying out repairs, only use spare parts supplied by IKUSI dealers.
WARNING
• The devices muts be used with the manufacturers’ batt ery and batt ery charger.
• The equipment must be operated by quialifi ed personnel.
• Aft er use, never leave the equipment ON (one or several transmitt ers). Always set the contact key and the
STOP butt on to switch off positi on of the equipment to avoid accidentally to acti vate manoeuvres –specia-
lly in crane maintenance purposes-.
• Do not use the set when visibility is limited.
• Avoid knocking or dropping the set.
• Do not use the set if failure is detected.
REMEMBER
Changes or modifi cati ons not expressly approved by IKUSI could void the user’s authority to operate this
equipment.
Remove the transmission key
only when the set is not in use or
to deny the access
When in doubt, press the STOP
button
Make sure the transmitter works
with the machine to be handled
After use set the contact key and
the STOP button
Do not use the set when visibility
is limited
Avoid knocking or dropping the
set
01- SAFETY INSTRUCTIONS
01-
S
AFETY INSTRUCTIONS
