On receiving a signal from the transmitter, the receiver will enter into de WORKING
mode. The following LEDs will light up on the receiver:
SIGNAL:
Flashing ON, indicating that it is receiving an RF signal at the working
frequency. (Now temporary ON fix).
POWER:
ON, indicating that the power supply is correct.
HARDOK: ON, indicating the absence of defects on the board.
ID:
Flashing ON each time a good frame is received with ID correct. This
means that the receiver has recognised the transmitter’s identification
code
DATA:
Flashing ON each time a good frame is received without caring about
ID. This means that the data received have a correct format.
After pushing the start button, the KSTOP 1 and KSTOP 2 relays will be activated.
K2/START and K12/HORN relays are activated only meanwhile the start button is
pushed.
Relays K13 and K14 on RADF13 system will be activated to the corresponding state of
the Hoist Selector.
Push any of the transmitter’s manoeuvre buttons and its corresponding relay should be
activated. The safety relay K1/SEC will also be activated.
Check to make sure all other manoeuvres work in this way.
Turn OFF the transmitter using the STOP button, and make sure that on doing so the
relays are deactivated and the DATA, ID and SIGNAL LEDs light as corresponding to
the SCANNING mode.
Reconnect the power supply to the motors, move to the usual work position and check to
see if all the manoeuvres and the STOP button are functioning correctly.
Remember that the receiver has several voltage-powered circuits. Even when the
receiver’s power supply has been cut off, there is still a risk of electrical shocks.
RADS11 and RADF13 Users Manual ver0.4a.doc
KCI Hoists Corp. reserves the right to modify this information without prior notification.
Page 12 of 23
