5 USE
To ensure correct use of the equipment, follow the instructions below:
Make sure the transmitter you are going to use is the right one, identifying the machine
on the identification label.
Attach the strap to the transmitter unit. Its use is recommended to prevent the
equipment from falling.
Introduce a charged battery, turn the contact key and activate the transmitter.
To activate the system, you must first pull out the STOP button, the transmitter LED
should then give a yellow-green pulse; then press the START button. If you find that
the STOP button has already been pulled out, it is necessary to push it in and then pull
it out again, as this sequence will allow the checking of the STOP circuit. If the unit
has experienced a time-out auto-disconnection, it is not necessary to repeat the STOP
button procedure, simply push the START button for 1 second.
The transmitter LED should light up in green, indicating that the transmitter has started
transmitting. From now on, if any of the transmitter’s command buttons are pressed,
the corresponding manoeuvre will be activated.
To be able to start up the transmitter, all the command pushbuttons must be in the
neutral position (not activated). This is not the case for the Hoist Selection functions.
When 4 minutes have passed and no active manoeuvre command has been activated,
the transmitter automatically switches off. To start it up once more, press the start
button.
The transmitter is equipped with a circuit for monitoring the battery level. When this
level drops below a pre-established limit, the transmitter LED starts to flash in red; 5
minutes later the transmitter switches off, and the machine’s main contactor is
deactivated. During this time, the load has to be located on a safe position.
In case of RAD-TF transmitter, the LCD display also shows the battery level of
charge: Three dots for charge bigger than 50%, two dots when 50% or less, one dot
when 10% or less, none when 5% or less.
To switch OFF the transmitter, press the STOP button or turn OFF the contact key.
Remember that you are going to remote control a moving piece of machinery. The
safety instructions described in chapter 3 of this manual must be strictly adhered
to.
RADS11 and RADF13 Users Manual ver0.4a.doc
KCI Hoists Corp. reserves the right to modify this information without prior notification.
Page 14 of 23
