TM70Bi V3.2 (11/02)
1121174 L0.pdf
18
IKUSI reserves the right to change this information without prior notice.
8.1 - SYSTEM DESCRIPTION
The TM70 radio system contains synthesized frequency radio modules in both transmitter and receiver
which are microprocessor controlled. This allows us to change the radio frequency via the transmitter
in a simple way and the receiver will automatically search for this new frequency.
8.2 - DEFINITIONS
ALLOWED CHANNELS (CP): is a list of authorized channels, (maximum 70). These are factory
defined and are not modifiable.
BASE CHANNEL (CB): this channel is defined as the Working Channel and these channels are
exportable; factory defined, it can be modified via the progamation mode. It is an inferior Working
Channel.
WORKING CHANNEL (CT): the working radio channel; it is defined as a displacement from the CB. In
the equipment that has this option, the CT is modifiable by the user via the transmitter, by means of a
command to carry out this effect.
EXPLORABLE CHANNELS (EC): they are the CT defined working channels, (maximum 16), that the
receiver is able to fast scan. The rest of the CP channels are also scanned although with a smaller
priority.
8.3 - BASE CHANNEL FREQUENCY CHANGE
The change of frequency is made via commands that in normal work mode will operate or move the
machine. It is very important to follow the programming sequence rigidly, as described below to avoid
any movements of the machine.
ENTERING PROGRAMATION MODE
In order to enter the progamation mode the following procedure must be followed:
Situate yourself in close proximity to the
receiver.
Turn the key to the on position and push in
the pull out the red stop. Girar la llave a la
posición de contacto.
Press the pushbutton (1) into the second
speed and then push the Start pushbutton
and hold both for 2 seconds. During this
time the LED will pulse red.
When entering the progamation mode, the
LED of the transmitter will flash orange for a
few moments. After a short pause, the LED
will indicate the Base Channel that is being
used by pulses of green or red in the
following manner:
tens by green colour pulses.
units by red colour pulses.
Thus for example, channel 42 would be indicated by means of 4 green pulses, followed by 2 red
pulses.
Next, the LED will again turn orange and the transmitter is now ready to await the introduction of
new data. At this point if you wish to leave the progamation mode, simply press the STOP.
