IKUSI TM70 Series, Service Manual

I K U S I

5

21/05/2008

1. Switch off the transmitter.
Remove the two screws 

of fixation

of the EP70 EEPROM module 

of

the damaged transmitter. In the EP70
EEPROM are stored the system
parameters.

1. Switch off the transmitter.
Remove the two screws 

of fixation

of the EP70 EEPROM module 

of

the damaged transmitter. In the EP70
EEPROM are stored the system
parameters.

2. Once the two fixation screws are
removed, 

extract the EP70

EEPROM module

from the damaged

transmitter.

2. Once the two fixation screws are
removed, 

extract the EP70

EEPROM module

from the damaged

transmitter.

3. 

Introduce the removed EP70

EEPROM module in the spare
transmitter. 

Once placed, to fix it,

tighten the two screws.

3. 

Introduce the removed EP70

EEPROM module in the spare
transmitter. 

Once placed, to fix it,

tighten the two screws.

4. In order to  work with the installed
EP70 EEPROM module,
introducing the battery,

turn on the

key to the ON position and push
and pull the Stop push button

.

The LED will light an instant in
orange-green, it will make some
blinks in green colour during about
15 seconds and it will get
extinguished. Pressing Start push
button the system will start to work
and the LED will get lit in green.

4. In order to  work with the installed
EP70 EEPROM module,
introducing the battery,

turn on the

key to the ON position and push
and pull the Stop push button

.

The LED will light an instant in
orange-green, it will make some
blinks in green colour during about
15 seconds and it will get
extinguished. Pressing Start push
button the system will start to work
and the LED will get lit in green.

CHART 2

CHART 2

SPARE TRANSMITTER PROGRAMMING

(USING ORIGINAL EP70)

SPARE TRANSMITTER PROGRAMMING

(USING ORIGINAL EP70)

C1

C6

C8

C9