HALLEY BKA 2000
Operating manual - English
12
5
MACHINE INSTALLATION AND PREPARATION
The HALLEY BKA 2000 key-cutting machine can be installed by the purchaser and does not require
any special skills. However, some checks and preparation for use need to be carried out by the operator.
5.1
Checking for damage
The HALLEY BKA 2000 is solid and compact and will not normally damage if transport, unpacking and
installation have all been carried out according to the instructions on the packing box.
However, it is always advisable to check that the machine has not suffered any damage.
5.2
Environmental conditions
To ensure that the best use is made of the key-cutting machine, certain parameters must be borne in
mind:
-
damp, badly ventilated sites should be avoided.
-
the conditions for the machine are:
- temperature: between 0 and 40°C
- relative humidity: approx60%
5.3
Positioning
Place the machine on a horizontal surface, solid enough to take the weight (26 Kg). To facilitate
operation and maintenance, install the machine with a clearance of at least 300 mm on all sides (fig.6).
Check that the weight of the machine is evenly distributed over the four feet; horizontal positioning
prevents vibrations during operation.
ATTENTION: ensure that the machine voltage is the same as that of the mains, which must be properly
earthed and provided with a differential switch.
Fig. 6
5.4
Description of work station
The machine needs only one operator, who has the following controls at his/her disposal:
•
Master switch (A), placed on the left-hand side of the motor; provided with a warning light
indicating that the machine is live.
•
Carriage lever handle (C).
•
Lateral movement lever (F).
30
0 m
m
30
0 m
m
30
0 m
m
