PK3561_10_09 • 79 SERIES INSTALLATION GUIDE
10
3.4 Install the Outside Housing and Inside Trim Assembly for 79 Series
(for 79 with Mechanical Override, see page 15)
A- For Mortise
1.Install the gasket (N) (if required) on the outside housing prior
to assembly, aligning the notch in the gasket with the battery
compartment. See page 3 for gasket information.
2. Insert the slotted end of the square spindle (G) into the out-
side lever hub until it locks, at an angle of 45º. (The spindle can
be removed by pulling on it, if oriented incorrectly.)
3. Insert the thumbturn spindle (F) in the upper hub of the
outside housing. (It will clip in place.)
If installing the lock with mortise outdoors, order the
proper Gasket (See page 3).
For doors more than 2 1/2" thick, order the appropriate
hardware bag to receive the correct length of spindles
and mounting screws. (See page 3)
i
4. Place the outside housing on the door so that the spindles
engage the hubs on the mortise.
For 79T Toggle Mode, insert cable W1 in hole H1 on the door
(See fig. above)
5. On the inside trim assembly turn the lever to the correct
horizontal rest position for the handing of the door. Install the
tension spring (L) between the handle (H) and the post (P).
For 79M with ASM Office and ASM/ESM Store-
room models, refer to Appendix A.2, A.3, A.4 at this point.
For 79M Cylindrical, refer to Appendix B.
For 79T Toggle Mode, see 2.6 on page 6
!
5. Put the thumbturn (T) in a vertical position. Place 3 spacers
(S) on the door (for recent models only) and place the inside
trim assembly on the door so that the upper and lower spindles
(F) and (G) engage the thumbturn and the inside lever. Fasten
to the outside housing using the three 1/8" hex drive mount-
ing screws (I ). Install the screws without tightening. Verify the
inside lever and thumbturn operates smootly. If not move the
inside and outside housings slightly. Then tighten the screws.
For Autodeadbolt only
, apply the privacy thumbturn sticker
as shown. If in doubt as to the direction of the arrow press the
auxiliary latch (X) to extend the deadbolt, and verify in which
direction to rotate the thumbturn to reach the horizontal (pri-
vacy) position.
Outdoor Gasket
Notch
Square Spindle Position
correct incorrect
H1
W1
(Toggle mode only)
RH/LHR LH/RHR
X
