14
ITP180B User Guide
Getting started
1
Use the
TAPE MEASURE
to decide
how high you’d like to hang the bar
speaker on the wall.
The bar speaker must be hung within
6 feet of an AC power outlet for the
attached AC Power Cord to reach.
2
Use the
STUD FINDER
to locate 2
parallel wooden studs to screw the
mounting brackets into.
3
Mark the wall at the center of the
studs using the pencil.
Line the
LEVEL
up on both of your
marks to make sure they are level.
If they’re not, adjust the marks as
needed to make them level.
4
After you’ve double checked your
markings,
DRILL
through the top hole
on both mounting brackets directly
into the marks you’ve made on the wall.
If you are using the brackets only and
no spacers, use the included short
screws. If you are using any of the
spacers or combination of the spacers,
use the long screws.
5
Use the
LEVEL
to level each of the
hanging brackets, then
DRILL
the
second screw into the bottom hole
on both mounting brackets.
6
Slide the bar speaker onto the mounting
brackets, and make sure there is a
firm and stable connection before
letting go of the bar speaker.
Finally, use the
LEVEL
to confirm
that the bar speaker is level.
POWER
SOURCE
VOLUME
PLAY/PAUSE
S
iPod DRAWER
LINE IN