M
o
n
ito
r
th
e
R
u
n
cBot 2 System Guide
55
Monitor the Run
1
Use the Run Status screen to monitor the run in progress.
The Run Status screen provides the run status and the following details:
}
Start date and time, end date and time, and time remaining
}
Cluster generation protocol steps with status bar for each step
}
Reagent currently in use
}
Current temperature (°C)
}
Status of the command in the current step
Figure 25
Run Status Screen
2
Wait for the run to complete:
}
HiSeq v4, HiSeq 3000/4000 PE, or HiSeq X—Allow approximately 3 hours.
}
HiSeq 3000/4000 SR—Allow approximately 4 hours.
}
HiSeq Rapid v2 or TruSeq Rapid—Allow approximately 1 hour.
}
TruSeq v2 or TruSeq v3—Allow approximately 5 hours.
3
After the run is complete, you can leave the flow cell on the instrument overnight.
Otherwise, proceed to unloading run components.
The cBot 2 holds the flow cell at 20°C.
Run Data Report
The run data report provides a summary of the run in progress. It lists the following
information:
}
Protocol name
}
Flow cell ID
}
Reagent ID
}
Template name
}
Start time and finish time
You can view the report at any time during the run. Select
Menu
and then select
Run Data
.
At the end of the run, the run data report automatically opens to alert you that the run is
complete.
Summary of Contents for cBot
