1
*SAVE THIS MANUAL FOR FUTURE REFERENCE
PRODUCT MANUAL
LIMITED ONE YEAR WARRANTY
ILLUMINATOR
™
Multi-Color LED Stake Light is backed by a Limited One Year Warranty. This warranty covers manufacturer defects
and workmanship. The warranty excludes misuse or abuse and normal wear and tear.
41927 MULTI-COLOR LED STAKE LIGHT
WARNING
CAUTION
When using outdoor use portable luminaires, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, and personal injury, including the following:
Make sure the installation follows all applicable local regulations
RISK OF ELECTRIC SHOCK
Do not use with extension cord near water or where water may accumulate
Keep lamp at least 16 feet away from pools, spas, and similar installations
Keep plugs and receptacles dry
For use only on GFCI protected circuits
D0 NOT SUBMERGE
Inspect light before each use. Do not use if housing, power cord or LEDs are damaged
INSTALLATION INSTRUCTIONS
JS PRODUCTS 6445 MONTESSOURI STREET LAS VEGAS, NV 89113
800.255.7011 | FAX: 775.898.8773 | WWW.JSPRODUCTS.COM
|
|
1. Use only three-wire outdoor extension cords that have three-prong grounding plugs and grounding receptacles
that accept the appliance's plug.
2. Ground Fault Circuit Interrupter (GFCI) protection is to be provided on the circuit(s) or outlet(s) to be used for
the wet location portable luminaire.
3. Use only with an extension cord for outdoor use, such as an extension cord of cord type SW, SW-A,
SOW, SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW, SJTW-A,
or SJTOW, SJTOW-A.
4. When an extension cord is used with this luminaire, the maximum cord length shall not exceed 50 feet
(15.2 m) from where the cord exits the luminaire to the receptacle.
1. Align hole at top of stake with hole at U bracket of holder.
2. Insert screw nut through holes aligned in previous step. Snugly install screw nut onto stake.
3. Push the ground stake into the ground so the light is positioned vertically.
4. Be sure to aim the light towards the item you want to have lighted.
5. Plug the power cord into a GFCI protected circuit only.
6. Loosen the side two nuts to adjust the light and then retighten them. Be careful not to over tighten the nuts.
7. Unplug the light before removing it from the ground and store in a dry location when it is not in use.
