Page 16 of 16
11. GENERAL NOTES
1. To meet the German VdS (VdS Schadenverhütung GmbH) requirements class CZ+ on
burglary threatened doors use D5S.XX0A.SB high security cylinder installed with a VdS
approved security lock furniture of class B or C. Such security lock furniture corresponds
to DIN 18 257 class ES 2 and ES 3.
2. To meet the Dutch SKG*** requirements use the D5S.XXXA.SB high security cylinder.
Consult iLOQ sales representative for correct configuration
3. Before fitting the cylinder to a fire/smoke resisting door, the fire certification should be
examined to ensure conformity. Consult iLOQ sales representative for correct
configuration.
4. In the case the panic mechanism of the panic mortise locks can be blocked or influenced
in a negative way by the cylinder cam, it is mandatory to install the panic cylinder
(D5S.7xx). The use of the other cylinder types (D5S.1xx/2xx/3xxx/4xx/5xx etc.) are only
allowed if the lock do not need a specific cam position resp. the cam could not block the
panic functionality. Please double-check the letter of conformity of the mortise lock
manufacturers.
5. When used in combination with panic locks, it is essential to ensure after installation that
all parts of the lock are in an operational condition and that the panic function of the
mortise lock is guaranteed.
6. Care should be taken to ensure that any seals or weather-stripping fitted to the complete
door assembly, does not inhibit the correct operations of the cylinder.
7. Care should be taken to ensure that no projection of the cylinder and associated parts, can
prevent the door swinging freely.
8. All components necessary for the specific installation should be fitted.
9. The key is to be kept securely so that only authorized person may have access.
10. In case of losing a key, blacklisting of the lost key shall be done with the iLOQ
Manager software and affected locks shall be reprogrammed.
11. Especially in industrial areas or near the sea, impurities can cause deposits in the form of
rust and attacked the material. This equipment should be cleaned and maintained
frequently.
12. Cylinder will lock, for security reasons, itself after 10 seconds, the key can then be removed
by turning it back to the 12 o’clock position (either clockwise or anti-clockwise).
13. In case of problems with functionality please check following points:
Check, if the locking cylinder is damaged.
Check, if foreign particles are present in keyway.
A wrongly located cylinder within the lock case due to incorrectly mounted
furniture.
A defective mortise lock.
Incorrectly mounted locking plates.
A warped door etc.
