Page 8 of 16
6. INSTALLATION OF ILOQ D5S.3XX SERIES
A. Loosen screw from thumb turn with 2 mm Allen key, turn them counterclockwise, that it is
possible to remove the knob (but do not screw them out completely).
B. Ensure the cam is pointing downwards and slide lock cylinder through the lock case.
C. Make sure the cylinder frame is a maximum of 1
.
0 mm from the door leaf or escutcheon.
D. Fix cylinder into lock case by iLOQ fixing screw (A10.64, part of the delivery), use tightening
torque 0.9...1.1 Nm. If necessary, cut the screw to the correct length (calculation screw length:
L = b 10 mm).
The screw has cutting grooves to make the cutting easier.
E. Thump turn knob in place.
F.
Tighten screw by turning the screw clockwise. Use tightening torque 1.5 Nm.
A.
B.
C.
D.
E.
F.
G.