iLOQ Oy • Oulu, Finland • www.iLOQ.com • iLOQ is registered trademark of iLOQ Oy •
©2018 iLOQ Oy. All Rights Reserved •
4. INSTALLATION OF THE F50S
To conform with FK* Class 3 requirements, use FK-approved (please note: key tube not included in
delivery). Mount the key tube according to the tube manufacturer’s instructions.
Additionally, pay attention to the instructions below to ensure conformity with the iLOQ Key tube lock
cylinder:
The tube shall be at a 4-degree angle to
prevent water pooling inside
Mount the key tube max. 5mm inside the
wall surface
Correct positioning of the iLOQ
Key tube lock cylinder inside the tube
In case an existing key tube is mounted too deep inside the wall and the iLOQ Key tube cylinder
cannot be placed in the key tube, it is possible to replace it with a version with a longer version.
Please refer to the instructions on the next page and the documentation of the key tube
manufacturer.
*) Finnish non-life insurers’ Federation (FK)
