18
TB-6Wxx500-I
BATTERY STATUS LIGHTS
Fault
Cause / Solution
At the end of the cutting cycle
No light
No malfunction
Red flashing light
Charge / substitute the battery (about 10% of the capacity)
Red light
Flat battery
After inserting the battery
Green light
No malfunction
Red light
Charge /replace the battery
MAINTENANCE REQUIREMENT LIGHTS
Fault
Cause / solution
At the end of the cutting cycle
green light
Operating value OK
green/red flashing
Operating value OK and interval of maintenance passed/due
red flashing
Operating value at limit / contact customer service
red light
Operating value faulty or hardware malfunction / request
assistance
orange light
Temperature error / warm or cool the tool
After inserting the battery
green light
No malfunction
orange light
Temperature error / warm or cool the tool
Tool Reset:
The cable cutter turns off and remains blocked. The service red or orange LED‘s light up.
Work can resume only after replacing the battery or after removing it for a moment and
then reinserting it. If, after you reset the tool, the issue persists contact the customer
service department (see back cover).
