Introduction
2
Ilumipod™ 54g2 IP User Manual Rev. 2
There are no
user-serviceable
parts inside this
product. Any reference to
servicing you may find in
this User Manual will only
apply to properly certified
ILUMINARC® technicians.
Do not open the housing
or attempt any repairs
unless you are certified to
do so.
Please refer to all
applicable local
codes and
regulations for the proper
installation of this product.
Keep this manual
for future
consultation. If
you sell this
product to another user,
make sure that they also
receive this manual.
In the unlikely
event that your
Ilumipod™ 54g2
IP may require service,
please contact
ILUMINARC® Technical
Support.
Safety Notes
Please read all the following Safety Notes carefully because they include important
information on how to install, use, and maintain this product safely.
Personal Safety
•
Avoid direct eye exposure to the light source while the product is on.
•
Always disconnect this product from its power source before servicing.
•
Always connect this product to a grounded circuit to avoid the risk of electrocution.
•
Do not touch this product’s housing when operating because it may be very hot.
Mounting and Installation
•
This product is for outdoor use and can be submerged (IP67) at a depth of 1 m or less
and for 30 minutes or less. Do not submerge deeper than 1 m for more than 30 minutes.
•
Not for permanent outdoor installation in locations with extreme environmental
conditions. This includes, but is not limited to:
o
Exposure to a marine/saline environment (within 3 miles of a saltwater body
of water).
o
Where the normal high or low temperatures of the location exceed the
temperature ranges in this manual.
o
Locations that are prone to flooding or being buried in snow.
o
Other areas where the product will be subject to extreme radiation or caustic
substances.
•
CAUTION: When transferring product from extreme temperature environments,
(e.g. cold truck to warm humid ballroom) condensation may form on the internal
electronics of the product. To avoid causing a failure, allow product to fully acclimate
to the surrounding environment before connecting it to power.
•
Make sure there are no flammable materials close to this product while it is operating.
•
When hanging this product, always secure it to a fastening device using a safety cable.
Power and Wiring
•
Always make sure that you are connecting this product to the proper voltage, as per the
specifications in this manual or on the product’s sticker.
•
Never connect this product to a dimmer pack.
•
Make sure that the power input cable is not cracked, crimped, or damaged.
•
Never disconnect this product by pulling on the power input cable.
Operation
•
The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at a
higher temperature.
•
In case of a serious operating problem, stop using this product immediately!
