Stereo Audio System for Your iPod
V11M11_IM_EN_01122007
www.i-Luv.com
- 11 -
GETTING STARTED
Installing the Remote Control Battery
The remote control battery is included. Before operation, please install it to the battery compartment of remote
control.
1.
Locate the battery compartment on the bottom of remote control and open.
2.
Insert a “
CR2025
” 3V lithium battery. Make certain to follow the correct polarity, following the directions of the
corresponding symbols (+/-) as marked.
3.
Secure the battery compartment by closing the cover.
Installing the AM Loop Antenna
For AM radio operation, locate the AM antenna jack on the back of the unit. Plug the AM loop antenna into the connector. To achieve the best reception
possible, a distance of 12” between the AM antenna, the unit and the iPod is recommended.
Installing the Dock Adapter
To ensure that your iPod will fit properly into the built-in universal dock, several detachable dock adapters for old iPod players
are included with this product. Please check the bottom of dock adapters to determine compatibility with your iPod.
1.
Inserting the dock adapter
a.
Choose a dock adapter that corresponds with the iPod you would like to dock. Using the correct dock adapter
ensures a proper fit.
b.
Gently push the dock adapter down into the universal dock.
c.
Carefully place your iPod into the universal dock. Please note that iPod must not be in a case or “Skin”.
2.
Removing the dock adapter
a.
Remove your iPod, grasp the dock adapter and carefully lift upwards.