9
Residual heat indication
After the heating zone is turned off, or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
When the residual heat indicators are on, don’t touch the heating zones and don’t put any heat
sensitive object on them. There are risks of burn and fire.
Booster function
The Booster function [ P ] and the Double Booster [
] grants a boost of power to the selected
heating zone.
If this function is activated the heating zones work for 10 minutes with an ultra high power.
Booster is needed for example to heat up large quantities of water rapidly, like for noodles
•
Start up / Stop the booster function:
Action
Control panel
Display
Start up the Booster
slide to the end of the “SLIDER”
[ P ]
or press directly on the end of
the “SLIDER”
Stop the Booster
slide on the “SLIDER“
[ 9 ] to [ 0 ]
•
Start up / Stop the double booster function:
Action
Control panel
Display
Start up the Booster
slide to the end of the “SLIDER”
[ P ]
or press directly on the end of
the “SLIDER”
Start up Double Booster
re-press key on the end of
the “SLIDER”
[
and P ]
Stop the Double Booster
slide on the “SLIDER“
[ P ] to [ 0 ]
Stop Booster
slide on the “SLIDER“
[ 9 ] to [ 0 ]
•
Power management:
The whole cooking hob is activated with a maximum limit of power. When the booster function is
activated, and in order to exceed the maximum power, the electronic system reduces the power
level of other heating zones. The display will blink on [ 9 ] for a few seconds and then shows the
maximum of power allowed :
Heating zone selected
The other heating zone:
(example: power level 9)
[ P ] is displayed
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Timer
The timer is able to be used simultaneously with all heating zones with different time settings
(from 0 to 999 minutes) for each heating zone.
•
Setting and modification of the cooking time :
Action
Control panel
Display
Select the power level
slide on the “SLIDER“
[ 1 ] to [ P ]
Select the Timer
press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Decrease the time
press key [ - ] from the timer
[ 60 ] to 59, 58...
Increase the time
press key [ + ] from the timer
Time increase
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
