8
ATTENTION
Rules for installation
ATTENTION
The instructions below are intended for the skilled technician who will install the cooker,
regulate it and perform technical maintenance and who will ensure that these operations
are carried out in the most correct way possible, in compliance with the regulations in
force.
Important: the cooker must be disconnected from the electric supply before per-
forming all regulating or maintenance operations.
• Installation must be carried out by a competent technician, fully complying with the legi-
slation in force regarding electrical installations. Otherwise, the manufacturer disclaims
any responsibility. You will find your appliance’s wiring diagram in this booklet.
• The appliances are prepared for connection to the voltage shown on the data plate.
•
Before connecting the appliance to the mains check that:
-the main cooker switch is able to support the appliance’s load(see dataplate);
-the power supply should be earthed as per the current regulations.
The appliance is supplied with a cable - This cable must be used for installation. The
connection must be made taking into account that the green-yellow cable is the earth
conductor and it must never be interrupted
It is necessary that:
- the installation can support the equipments load. (see data plate)
- the power supply system must have an efficient earth.
- the cooker switch must have a minimum 3 mm, double pole contact opening and must
be easily reachable once the appliance has been installed.
- means for disconnection must be incorporated in the fixed wiring in accordance with
current regulations.
The yellow-green earth wire must never
be interrupted even by the switch.
The power cable should be positioned
so that it does not come into contact with
surfaces that have a temperature of 50 °C
higher than the environment. In case repla-
cement of the power cable is necessary,
contact the support service.
ELECTRICAL CONNECTIONS
Groups of cooking
Summary of Contents for MAJESTIC MILANO 06
