Flextight Damaged Original Kit Instructions
Using the Kit
Cleaning the Original
9
6.
Position the original on the marks on the mounting plate.
7.
Apply another ÒTÓ of gel on top of the original.
8.
Close the foil.
9.
Get the roller and place it at the top of the foil. Gently apply pres-
sure and roll from top to bottom to get an even distribution of gel
on the original.
10. Remove the foil from the mounting plate without opening the foil
and mount it as usual in a Flextight original holder.
11. Be sure to keep the gel tube sealed by replacing the applicator cap.
To store the gel for a longer period of time, remove the applicator
and replace the tube cap.
Cleaning the Original
1.
Remove the foil from the Flextight original holder.
2.
Remove the original from the foil and discard the foil. (ReÞll kits
that include more foils and gel are available from Imacon.)
3.
If necessary, pour some cleaner into your cleaning tray (see ÒAddi-
tional Materials RequiredÓ on page 7 for more information about
these items).
4.
Place the original in the tray.
5.
Place the lid tightly on the tray.
6.
Gently rock the tray back and forth for one or two minutes.
7.
Open the tray, remove the original and seal the tray again.
8.
Put the original on a lint-free cloth and gently wipe it clean of
excess solvent.
