Page 20
Setup Manual
B.2.2
Inserting the transportation locks
Attention
Insert the transportation locks
before transporting the scanner
to protect the camera box against damage.
Before inserting the transportation locks the camera box unit must be moved into transport
position.
The transport position of the camera box unit is at the back side of the scanner – seen
from the operator’s position.
When the power down sequence ends normally, the camera box unit moves to its
transport position. If the camera box unit is in any other position after switching off, restart
the scanner.
Turn it off again. The power down sequence moves the camera box unit to the transport
position, finalizes all internal processes in the scanner and switches the device to
stand-by mode.
Finally switch off the WideTEK 25-600 at the main power switch (see Picture 7).
Insert the transportation locks at both sides of the scanner carefully.
Always use the transportation locks which come with the scanner.
Important:
Tighten the transportation locks only by hand. Using more force could result
in damage of the camera box unit.
