Page 46
Setup Manual
D.3.2.3
IPv4 (Network Interface 1)
The function
IPv4 (Network Interface 1)
allows the operator modifying the parameters for
the “Network Interface 1”. This is the secondary network and used for communication with
internal network devices, e.g. the WLAN module.
Picture 25: Settings of IPv4 (Network Interface 1)
The screen shows the parameters for the “Network Interface 1”.
The IP address 10.0.0.50 is pre-configured for the communication with the WLAN module.
Default IP address of the WLAN module: 10.0.0.1.
IP address
Enter the IP address for the “Network Interface 1”.
Subnet Mask
Enter the value for the subnet mask.
Default Gateway
Enter the value for the gateway.
After modifying the network parameters, click on the Apply button to transfer the new
settings to the scanner. The “Network Interface 1” is now accessible with its new IP
address.
Note:
Depending on the browser used, it is necessary to delete the browser cache
before the scanner is accessible.
