A.6.2
Turning-off the WideTEK 36
Note:
Always
turn off the WideTEK 36 scanner with the
Stop
button on the
touch panel!
The main power switch should only be used when the WideTEK 36 is
in stand-by mode and
before
the scanner is disconnected from the
electrical outlet.
To turn the WideTEK 36 off, press and hold the
Stop
button on the touch panel.
While the
Stop
button is held, a counter in the button shows the remaining time until the
WideTEK 36 is powered down.
“Going to sleep in x seconds”
Picture 22: Touch panel while shut down in progress
At the end of the power-down sequence the display will be dimmed.
A.6.3
The Help Function
To support the user when working with the WideTEK 36, a help function is integrated into
the touch panel menus. A
Question Mark
(?) symbol in the lower right corner of the
screen activates the help function.
After touching the question mark, all controls in the screen start blinking. To get the
corresponding help text, the appropriate control must be touched. To return to the
respective screen, the screen must be touched again on any arbitrary place.
Page 28
Setup and Assembly Manual
