Image Engineering
Seite
5
von
12
2 GETTING STARTED
2.1 Scope of delivery
•
iQ-Near Focus
•
3 m cable (male 6.35 mm TRS connector to male 3.5 mm TRS connector)
•
Hex keys for frame assembly
2.2 Commissioning
The iQ-Near Focus comes almost ready to use. The following assembly steps need to be performed
before using it:
•
Step 1: Mount the feet of the frame to the lower frame using the hex keys.
•
Step 2: Cover open mounting brackets and profile surfaces with plastic caps.
•
Step 3: Join the upper and lower part of the frame by sliding the gliders into the
corresponding grooves, as shown in step 3 below.
Step 1:
Guide the slot nuts into the corresponding groove on each foot profile (Figure 2). Slide on until the
hole in the foot profile aligns with the screw head between the four slot nuts (Figure 3). Tighten screw.
Figure 2: Frame assembly
