Image Engineering
Seite
9
von
12
3:
Green “Referenced” LED:
Lights up after successful initialization and homing
process after switching on the device. When the green LED is on, iQ-Near Focus is
ready for use.
4:
“
Homing
” Button.
Manually restart the homing process in case the test chart has
been moved by hand or you are unsure if the initial homing after startup is still valid.
5:
“
Stop
” function
: Stops the device immediately, regardless of the current chart
position.
“Reset” function:
Resets the device in case of an error and turns off
“Error” LED.
“Profile” function:
iQ-Near Focus has two modes of movement.
1.
Starting at the top position: Quickly move down to clear the camera's FOV,
stay down for the set duration and then slowly move back up.
2.
Starting at the bottom position: Quickly move up into the camera’s FOV, stay
there for the set duration and then slowly move down to the starting position.
Hold the "Stop/Reset, Profile" button to switch between these modes. The display will
show "P1" or "P2". Switch profiles by pressing the "+" or "-"button. The display will
automatically show the set delay again when releasing the "Stop/Reset, Profile"
button.
6:
“Start” Button:
Starts the device using the previously set parameters.
7/8:
“+/-“ Buttons:
Increase/decrease the delay between movement steps of whole
seconds. These buttons also cycle through movement modes (see label 5)
“Profile”
function
.
9:
Start
“manually” (2.5 mm TRS jack socket):
Typically used to connect a standard
remote shutter release.
10:
Start
“LED-Panel” (3.5 mm TRS jack socket):
This socket connects the iQ-Near
Focus with the LED Panel to start both devices simultaneously with a remote shutter
release.
3.2 Height adjustment of frame
The upper part of the frame is height adjustable. The center of the chart resting in its upper position
can be set to a height between 132 cm and 165 cm. We recommend changing the height with the help
of another person.
