Image Engineering
Seite
3
von
14
1 INTRODUCTION
Important information: Read the manual carefully before using the device.
Inappropriate utilization may cause damage to the device, to the DUT (device under test), and/or other
components of your setup.
Keep these instructions in a safe place and pass them on to any future user.
1.1 Conformity
We, Image Engineering GmbH & Co. KG, hereby declare that the LG3 corresponds to the essential
requirements of the following EC directive:
•
Electromagnetic Compatibility - 2014/30/EU
•
Photobiological safety of lamps and lamp systems - IEC 62471:2009
1.2 Intended use
The LG3 is a high-intensity illuminator based on LED technology for transparent charts. It is capable of
flicker generation with variable frequency and variable duty cycle. The external controller unit and the
LG3 Software can control the device.
•
Only suitable for indoor use.
•
Place your system in a dry, constant tempered environment without light interference.
•
The optimal ambient temperature range is 22 to 26 degrees Celsius. The maximum
ambient temperature range is 18 to 28 degree Celsius.
•
The system has an internal temperature management system, if there is any error
regarding the internal temperature, you will get a warning message, and the system
automatically turns off to avoid any damage.
1.3 General safety information
Do not
open the device without instructions from the Image Engineering support team and when
connected to the power supply.
1.3.1 Photosensitive epilepsy
A few users with pre-existing conditions may experience seizures while using the
flicker mode of the LG3. Certain frequencies and intensity combinations may trigger
seizures with no prior medical history. Reframe using the device and consult a doctor
immediately if you experience sickness while using the LG3.