Image Engineering
Seite
11
von
11
Figure 11: Set Measured Value
Cancel the calibration to retain the old calibration. Press OK to accept your calibration.
Note that luminance or illuminance only show if “Flicker” is set to 0.0Hz continuous mode.
5 ADDITIONAL INFORMATION
5.1 Maintenance
•
Do not touch, scratch, or pollute the diffusor.
If there is any dust on the diffuser, clean it with compressed air or an air blower.
5.2 Storage and Transport
•
Store and transport the Vega only in the delivered hard case.
5.3 Disposal Instructions
The Vega must be disposed of properly after the service life is over. Vega includes electrical
and electromechanical components. Observe your national regulations. Make sure that third
parties cannot use Vega after disposing of it.
Contact Image Engineering if assistance for disposal is required.
6 TECHNICAL DATASHEET
See the website of Image Engineering: