Image Engineering
Seite
8
von
11
4.3 Operation
Figure 5: Vega
The Vega controller and the modules are displayed in the devices list
①
with the corresponding
serial numbers and CAN IDs. Select a device to make it controllable in the control panels at the
bottom. The Vega modules can work in flicker or continuous mode. If you want to work in
continuous mode, set the “Flicker” slider to 0.0Hz. If not, set them to your desired flicker frequency
by adjusting the slider or entering the value directly. If you are working in flicker mode with multiple
modules, you can synchronize them. In this case, the master module is CAN_1. Synchronize the
frequency of the modules to CAN ID 1 by checking the box next to the module. This
synchronization also overwrites the previously set Flicker, Duty Cycle, Angle, Period Count, and
Flicker Mode with the settings of the CAN_1 module. All Vega modules are set to synchronize by
default.
4.3.1 Module Controls
The following controls can be set individually for each module.
•
ON/Off state
: Each module can set the On/Off state, Flicker Mode, Intensity Interval,
Phaseshift, Intensity, Flicker, and Duty Cycle. To switch a module on or off, select it and
click on the light bulb
③
.