6
2
2
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
20
43
1
99
42
31
41
2. Whilst another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (42) to
the Lower Wire Harness (43). Gently pull the upper
end of the Upper Wire Harness to remove any slack
from the Wire Harnesses.
Turn the Adjustment Knob (20) counterclockwise two or
three turns to loosen it. Next, pull the Adjustment Knob,
insert the Upright (2) into the Frame (1), and then
release the Adjustment Knob. Be careful to avoid
pinching the Wire Harnesses (42, 43). Move the
Upright up and down slightly until the pin on the
Adjustment Knob is inserted into one of the holes
in the Upright. Then, turn the Knob clockwise until it is
tight.
Tighten the M6 x 25mm Button Screw (99) into the
Frame (1).
Attach the Bottle Holder (31) to the Upright (2) with two
M4 x 12mm Screws (41).
3
4
2
42
41
41
Console
Wire
4. Attach a Seat Handlebar (3) to the Seat Bracket (11)
with two M8 x 38mm Button Bolts (96) and two M8
Nylon Locknuts (49). Make sure that the Nylon
Locknuts are resting in the hexagonal holes in the
front of the Handlebar.
Attach the other Handlebar (3) to the Seat Bracket
(11) in the same way.
11
3
3
96
49
4
3. Whilst another person holds the Console (4) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (42). Insert the
excess wire harness down into the Upright (2).
Attach the Console (4) to the Upright (2) with four M4
x 12mm Screws (41). Be careful to avoid pinching
the wire harnesses.
